Click here to print this page

Planning Retirement Online


50plus Handyman             May 2006

Handyman Logo

The handyman column 
By Roger Runswick
 

Creating a cloakroom and shower

50plus Handyman director Roger Runswick looks at lighting and fitting additional power sockets

 

A recent customer of 50plus Handyman (let’s call her Mrs B) had a problem. Her husband was coming out of hospital and whilst recuperating needed to live ‘downstairs’. In the first instance, a downstairs cloakroom was required. And later a shower. But was this feasible?

The first question was one of space. For a cloakroom, an enclosed area is needed. Often under the stairs is the answer, and in Mrs B’s case there was space available in what was a large cupboard. So far so good!

The major issue with cloakrooms is the drainage and water supply. Water is usually the easier to solve as cold water for a basin and toilet only requires a single 15mm pipe. Hot water can similarly be piped in or an electric hand wash unit added. In Mrs B‘s home, water was available in the nearby kitchen so another tick in the box!

Drainage is usually another matter. Most people think in terms of a 110mm (4 inch) soil pipe for the toilet. If it’s feasible to get one in and connect to the main sewerage then this remains the best solution. However all is not lost if this isn’t possible or is too costly or disruptive. For Mrs B the answer lay in a macerator. (If you’re having breakfast at the moment skip the next bit.) Put simply, a macerator mashes up what comes out in the loo before pumping it out. The benefit is that a small (32mm) diameter pipe can be used in place of the usual soil pipe. Coupled with the fact that a macerator can also pump vertically and/or horizontally for quite some distance, it allows a loo and adjacent basin to be fitted into an area where a conventional waste system couldn’t function. A macerator is electrically powered and operates automatically. It locates immediately behind the toilet pan and under the cistern so is unobtrusive. For Mrs B the problem was solved.

Modern techniques have also provided a ready solution to the shower problem. Building a shower using conventional techniques means walls and tiling. Now a number of companies manufacture ‘all in one’ shower cubicles that can be fitted into a bedroom or similar space, providing a small diameter waste pipe can be connected and a cold water supply laid on. Connect up the waste, fit an electric shower and you have a readily available, conveniently located shower without major construction works. Such showers also have the added benefit that a leak is a lot less likely to develop.

A few points to note. Fitting an electric shower means making sure that your property has an electrical system that can accept the relatively heavy current connection required. In many cases this means bringing the earthing up to date. If the shower is going in a room such as a bedroom (or any room other than a bathroom), then a modern consumer unit is going to be needed. The power sockets in the room will need to be run via a safety device called an RCD. Most modern properties will already have one.

 
Roger Runswick is a director of 50plus Handyman and a member of the Institute of Electrical Engineers. He can be contacted at roger.runswick@the50plus.co.uk .


Previous articles in this series:

 

Fixing drips and changing your taps

Can I still change my light switch?

Fitting an outside light

Pre-winter maintenance

Thinking of installing a shower?

Decorating – are you getting your money’s worth?

Estimate or quotation?

Replacing a door?

How to upgrade the lighting in your home

Creating a cloakroom and shower
 



Bookmark


Advertise on laterlife.com



LaterLife Travel Insurance in Association with Avanti